What preparations should be made before China automatic blow molding machine is turned on?

Kingplas | Chinese Extrusion Blow Moulding Machine Factory

There are many small print within the preparation of China automatic extrusion blow molding machine and extrusion blow molding machine before beginning the machine:
First point: The cooling water for the cooling barrel should be open.
Second point: heat up the hydraulic oil. If the temperature of the hydraulic fluid within the blow molding machine tank is just too low, the heater ought to be turned on like a shot.
The third point: press the beginning button and stop like a shot, check whether or not the running direction of the pump is correct. If it's found that it doesn't correspond, like a shot modification the ability line of the two-phase receiving motor.
Fourth point: The machine ought to be turned on while not pressure on the mechanism. once turned on, regulate the pressure of every pump's overflow system to a secure pressure. every unit contains a pressure relief area. when the pump is stopped, the pressure vent valve should be opened. once the pump is running, the pressure is ventilated and also the valve should be closed.
Fifth point: regulate the position of all strokes.
Sixth point: shut the safety door. once gap the security door on the operational aspect, all safety doors ought to be closed once the machine is functioning consistent with the security needs. The pump can clean up once the security door is opened.
Seventh point: activate the heating and temperature regulation system.
Point 8: The mildew surface and also the contact surface with the extrusion blow moulding machine guide should be cleansed before putting in the mold.
The ninth point: the extrusion blow molding machine activates the most switch of the management cupboard, and adjusts the operation choice switch to jog or manual.